Microfiber insulated inflatable with integrated pump
Designed to withstand even the worst conditions. No cold joints and a height that reliably dampens even branches and cones - That's Skyline.
As a material, we used proven polyester with a lamination of an impermeable membrane, equipped with RipStop treatment in the shape of diamonds - this increases the durability of the fabric and prevents further rips in the event of a tear. The two valves are made of nylon and the draining one is also equipped with a silicone flap for 100% sealing.
The chambers of the mat are connected in an H shape, which does not create cold joints and at the same time prevents the air inside from swirling. In addition, BHB microfiber insulation is glued to the chambers from the inside, which significantly increases thermal comfort.
Thanks to the integrated pump, you will no longer have to struggle with inflation, no more dizziness or dizziness. Simply open the valve and after two minutes of stomping, you're ready to lie down.
Technical parameters
| Parameters | |
| Dimensions | 183 x 57 x 6 cm |
| Face | Rectangle |
| Mass | 880 g |
| Outer material | Polyester Ripstop Diamond, TPU Lamination |
| Bottom material | Polyester Ripstop Diamond, TPU Lamination |
| Valve | DLF - Dual layer flat valve |
| Repair set | Yes |
| Transport packaging | Yes |
| Type | Inflatable |
| Height | 6 cm and more |
| Dimensions after packing | ⌀13 x 32 cm |
| Temperatures | |
| Approximate value of thermal resistance | 1.8 R |
And how is it handled?
The integrated foot pump is in principle a very simple device. It consists of a chamber made of impermeable foam, a one-way valve and a lid.
After you open the lid, the chamber fills with air. Your task is to step on the entire chamber so that you block the opening with your foot and push the air out of the chamber through the flap into the mat.
You then lift your foot so that new air from the outside enters the chamber and step down again as described above. Repeat this until the mat is inflated and then close the lid.
The last step is to make sure the silicone flap in the drain valve is tight. You do this by unscrewing the valve cover and observing the following three options.
- You hear a short blow and it suddenly stops - the damper was loose but just clicked into place and everything is OK
- You can't hear anything - the valve is already in place - everything is OK
- It can happen that the flap gets stuck and the entire mat deflates - you need to gently direct the flap into place by tapping or pressing. Repeat the whole process.
Lamination
In order to prevent air leakage through the top fabric of the mattress, an impermeable membrane is laminated on the Polyester fabric. Lamination of a continuous membrane instead of applying a screed eliminates the possibility of applying an uneven layer of screed in places with material irregularities. This can lead to the application of an insufficient coating layer and air leakage in such affected areas. The use of PU foam with a thermally laminated membrane (TPU) is the highest quality material combination on the market today.
"H" Chamber shape
The upper and lower fabrics are not connected directly, which would create cold joints, instead they are connected by a partition that holds the shape and at the same time allows for perfect thermal insulation.
In addition, a thin layer of BHB Micro insulation is attached to the inside of the chambers, which maximizes the insulation effect while having almost no effect on weight and packability.
No reviews found